Stop Lamp Switch, Stop Lamp Inhibit Relay (except MK25E) SRT8: Heated Seat Module, Zener Diode, Fuse (Luggage Compartment): '30'ĭata Link Connector, Occupant Classification System (LHD), Ignition Switch (Engine Control Module (Diesel), Powertrain Control Module, Lock Steering Column Module (RHD), Fuel Pump Relay (Gasoline), Fuse (Luggage Compartment): '27', '29', '40', Diode No.1)Ī/C / Heater Control, Sentry Key Remote Entry Module (LHD), Cluster, Intrusion Transceiver Module (RHD)Ĭluster, Lock Steering Column Module (RHD), Sentry Key Remote Entry Module (RHD) Gasoline: Air Conditioner Compressor Clutchįuse (Luggage Compartment): '14', '36', '38', '44'Įngine Compartment Fuse Box (Fusible Link 14)Įxecept SRT8: Heated Seat Module, Zener Diode, Fuse (Luggage Compartment): '30' HID: High Intensity Discharge Lamp Relay (Fuse (Engine Compartment): '1', '2')ĭiesel: Air Conditioner Compressor Clutch Relay Radiator Fan Control Relay, Air Conditioner Compressor Clutch Radiator Fan (High) Relay, Radiator Fan Control (High/Low) Relay, Front Control Module SRT8: Fuel Injector, Ignition Coil, Ignition Capacitorĭiesel: Engine Control Module, Glow Plug Module, Oxygen Sensor, Intake Swirl Servo Motor, Crankcase Vent Heater, EGR Valve, Boost Pressure Servo Motor, Air Conditioner Compressor Clutch, Fuel Pump Relay, Gasoline (execept SRT8): Fuel Injector, Ignition Coil, Ignition Capacitor, Short Runner Valve Solenoid (3.5L)Ģ005: Fuel Injector, Ignition Coil, Ignition Capacitor Powertrain Control Module, Starter Relay, Engine Control Module (Diesel)ĭiesel: Engine Control Module, PTC Relay No.1, PTC Relay No.2, PTC Relay No.3 Park Lamp Relay (Front Park/Turn Lamp, Front/Rear Side Marker Lamp, License Lamp, Tail/Stop Lamp or Tail/Stop/Park Lamp), Front Control Module

Horn Relay, Front Control Module, Air Conditioner Compressor Clutch (Gasoline) If a properly rated fuse continues to blow, it indicates a problem in the circuit that must be corrected.Ī front power distribution center is located in the engine compartment. The use of a fuse with a rating other than indicated may result in a dangerous electrical system overload. When replacing a blown fuse, it is important to use only a fuse having the correct amperage rating.Failure to do so may allow water to get into the Power Distribution Center, and possibly result in an electrical system failure. When installing the Power Distribution Center cover, it is important to ensure the cover is properly positioned and fully latched.If a fuse blows again contact a qualified service center.

This can cause damage to the electrical system and fire.

Do not repair fuses and never replace a blown fuse with one that has a higher amp rating.

Before replacing a fuse check that the key has been removed from the ignition and that all the services are switched off and/or disengaged.

2005 chrysler 300 stereo wiring diagram